Which partition should be active windows 7

WHICH PARTITION SHOULD BE ACTIVE WINDOWS 7 INSTALL

Unlike a primary partition, you don't need to assign it a drive letter and install a file system. Modern versions of Windows allow up to four primary partitions, or three primary and one extended partition (which we'll discuss next) on a single disk.ДЄn extended partition is a partition that can be divided into additional logical drives. Although a primary partition can exist without an operating system, on older Windows and DOS operating systems, the first partition installed had to be a primary partition. A primary partition with an operating system installed on it is used when the computer starts to load the OS. The two types of partitions are: в–ЄДЄ primary partition is a partition on which an operating system can be installed. On computers running Linux, DOS, or Windows operating systems, different kinds of partitions may be used. This allows you to use features that are unique to different file systems on the same computer. Similarly, one partition of a Linux computer could be formatted as ext and another could use ext2. For example, on one volume of a Windows computer, you could have C: formatted as FAT32 and D: formatted as NTFS. If more than one partition is set, multiple file systems supported by the operating system can be used on a single HDD. When an area of the hard disk is formatted and issued a drive letter, it is referred to as a volume. Once a partition is set, it can be given a drive letter (such as C:, D:, etc.) and formatted to use a file system. Even if different partitions aren't used, and the entire disk is set up as a single partition, a partition must be set so that the operating system knows the disk is going to be used in its entirety.

A partition is a logical division of the hard disk, allowing a single hard disk to function as though it were one or more hard disks on the computer. In The Official CHFI Study Guide (Exam 312-49), 2007 Disk PartitionД«efore a hard disk can be formatted to use a particular file system, the hard disk drive needs to be partitioned. home вЂ“ Do not copy your home directory that you mounted over NFS. The remainder of /dev is populated by a program called udev. dev вЂ“ You only want the part of /dev that is on the microSD card. boot вЂ“ Do not copy the /uboot directory. A few directories require some special attention: You can just execute a mkdir command for these. Note, incidentally, that there are several top level directories that are empty. I suggest copying each top level directory separately, rather than everything in one big cp вЂ“r command. Now copy the entire target file system into that directory. Create a subdirectory under your home directory to match what you specified for rootpath in uEnvnet.txt. What you can do is copy from the BBB eMMC over the network to your workstation. You do not want to copy it from the microSD card, because that image is specifically intended for flashing the eMMC. It boots Debian 7.4 from the eMMC.ДЇinally, you need to get the target root file system on to your workstation under your home directory.

Power down the board, remove the microSD card and repower the board. When the four LEDs come on steady, the flashing is finished. That something else is flashing the eMMC. But the pattern of the LEDs indicates that something else is going on. The kernel will boot up as normal, and present a login prompt. In my case, the mere presence of a microSD card causes the board to boot from the card. The BBB documentation says that to boot from the microSD card, you must hold down the boot pushbutton while applying power.

Insert the microSD into your unpowered BBB. This image is specifically for flashing the eMMC. When it is finished, there will be two partitions on /dev/sdb a bootable FAT partition named BEAGLEBONE, and an ext4 partition named eMMC-Flasher. Write this file to the microSD card with the dd command:Дd if= of=/dev/sdb

Which partition should be active windows 7